Best Lighting Display Board Factories – Remote control bright emergency warning system LED display CJXP2010 – Honson

Safety Cautions

1. Only trained personnel could install, use or maintain this system.
2. Before connecting with the electrical source and operating the equipment,
please first confirm its above rooms is enough for rising LED display,
(especially when the vehicle goes through the bridge or underground stopping
place ) to avoid the equipment strikes to block or barrier, person injured or
dead, equipment damaged .
3. When install the equipment, please make sure to assemble a total fuse at the
distance of 15cm between the battery to prevent the equipment or back-end
circuit occur short circuit and cause the fire or other major accidents.

4. Do not operate the equipment in the danger zone, such as paint, gasoline,
solvent and explosive material existing; in the ventilated bad and high
temperature area. If touch with inflammable, explosive or other dangerous
material, may lead to fire, explosion, fire disaster or cause casualties.
5. When the equipment is added to be assemble to other system, such as warning
light, siren, please read the relative instruction manual.
6. The vehicle’s voltage should be consistent with the operating voltage of the
system.
7. It is forbidden to rise the LED display when the vehicle driving speed
≥30km/h
8. It is forbidden to rise the LED display when the wind speed ≥5 class

Installation Steps

1). The equipment need to be placed on the roof carefully and in the appropriate parts of the Roof;
2). bolt and supporter in attachment are used to tighten the foot stand and vehicle.
Warning: There should be no loose or dangerous when the step two is finished.
PLEASE PUSH FORWARD AND BACK TO CHECK.
3). The line of equipment data leads to the display controller inside the car through the
sink of the roof of the car and connected with the display controller.
4). The display bracket being fastened in the driver seat in the cab with screws, easy to Operate;
5). Connect power to the car battery through the roof tank, and less than 15cm away From the battery positive, a 10A fuse in series connection.